Skip to the manual
GeoTerva Free for 7 days

Slope stability: the user manuals

Two modules give the factor of safety of a slope: one finds the critical slip circle by the method of slices, the other takes a plane parallel to the ground. This page helps you choose the module that matches your slope and links to the manual of each.

Updated 22 October 2026 · GeoTerva user manual

Which slope module do I need?

The Slope Stability family has two modules. Both give a factor of safety against sliding. They differ in the slip surface. Pick the one that matches the slope you are checking.

Your slopeModule
A section with layers, groundwater, loads or reinforcement, where the critical slip circle has to be found by the method of slicesSlope stability
A long uniform slope, where sliding happens on a plane parallel to the ground at a given depth, dry, with seepage or with an earthquakeInfinite slope

The two manuals

Each manual follows the same plan: what the module calculates, what you need before you start, a quick start, the screen, every input section by section, the choices that decide the margin, the results, the report, a worked example you can reproduce, a table of how each input changes the answer, the messages the module gives, and answers to common questions.

What the two modules share

  • The workspace. The drawing, the tabs, Analyze and the input lock, units and the report follow the same layout as the other GeoTerva modules. See the workspace guide.
  • The factor of safety. Both give a factor of safety against sliding, to compare with the value you require.
  • Groundwater. Both take the water in the slope into account.
  • An earthquake. Both can add a pseudo-static earthquake, with the horizontal and vertical coefficients you enter.

What each module takes, side by side

Slope stabilityInfinite slope
Slip surfaceCircle, found by a searchPlane parallel to the ground
GroundLayersOne uniform soil
Also takesLoads, nails, anchors, geogridsSeepage or a pore pressure ratio

A typical slope check in order

  1. Choose the module

    Pick the one that matches the slope and open its manual for the fields.

  2. Describe the slope

    Draw the ground, or give the slope angle and the depth of the plane.

  3. Describe the soil and the water

    Enter the strength and the unit weights, and the water.

  4. Add the loads and the earthquake

    Enter any surface loads, reinforcement and seismic coefficients.

  5. Analyze and read the factor of safety

    Press Analyze. Read the factor of safety, then save a report with the cover filled in.

Frequently asked questions

How do I check the stability of a slope with GeoTerva?

Open Slope stability for a section with layers, or Infinite slope for a long uniform slope. Describe the slope, the soil and the water, press Analyze, and read the factor of safety.

Which methods of slices does the Slope stability module use?

The ordinary method, Bishop’s simplified method and Spencer’s method.

Can I add soil nails or anchors?

Yes. The Slope stability module takes soil nails, ground anchors and geogrids.

Which module do I use for a long slope with seepage?

Infinite slope. It takes the water table with seepage parallel to the slope, or a pore pressure ratio.

Can I include an earthquake?

Yes. Both modules take a pseudo-static earthquake with horizontal and vertical coefficients that you enter.