Skip to the manual
GeoTerva Free for 7 days

Liquefaction: the user manuals

Two modules give the factor of safety against liquefaction with depth for a site with several boreholes or soundings, from SPT blow counts or from CPT cone resistance. This page helps you choose the module that matches your test and links to the manual of each.

Updated 22 October 2026 · GeoTerva user manual

Which liquefaction module do I need?

The Liquefaction family has two modules. Both work out the factor of safety against liquefaction with depth for a site with several boreholes or soundings, and mark the triggered and marginal zones. They differ in the test you have. Pick the one that matches your site investigation.

Your testModule
Standard penetration test blow counts in boreholesSPT triggering
Cone penetration test readings in soundingsCPT triggering

The two manuals

Each manual follows the same plan: what the module calculates, what you need before you start, a quick start, the screen, every input section by section, the choices that decide the answer, the results, the report, a worked example you can reproduce, a table of how each input changes the answer, the messages the module gives, and answers to common questions.

What the two modules share

  • The workspace. The drawing, the tabs, Analyze and the input lock, units and the report follow the same layout as the other GeoTerva modules. See the workspace guide.
  • A project of many tests. Several boreholes or soundings in one project, entered one by one or filled in from an Excel template.
  • The earthquake. You give the magnitude and the peak ground acceleration of the site.
  • The factor of safety with depth. The cyclic stress ratio, the cyclic resistance ratio and their ratio at every reading.
  • Colour-band sections. The factor of safety is drawn as a colour-band section between the boreholes or soundings, with the triggered and marginal zones marked.
  • The report. A project summary and a Word report close the work.

What each module takes, side by side

SPT triggeringCPT triggering
TestSPT blow countsCPT cone resistance
MethodIdriss and Boulanger (2014)Boulanger and Idriss (2014) or Robertson and Wride (1998)
Also takesFines content, unit weightsSoil behaviour index, cone data

A typical liquefaction check in order

  1. Choose the module

    Pick the one that matches your test and open its manual for the fields.

  2. Enter the tests

    Type the boreholes or soundings, or fill in the Excel template and load it.

  3. Enter the water and the earthquake

    Give the water table, the magnitude and the peak ground acceleration.

  4. Analyze and read the profile

    Press Analyze. Read the factor of safety with depth and the colour-band section, then save the report.

Frequently asked questions

How do I check liquefaction with GeoTerva?

Open SPT triggering for blow counts or CPT triggering for cone readings. Enter the boreholes or soundings, the water table, the magnitude and the peak ground acceleration, press Analyze, and read the factor of safety with depth.

Can I enter several boreholes?

Yes. Both modules take several boreholes or soundings in one project, entered one by one or loaded from an Excel template.

Which methods do the modules use?

SPT triggering uses the procedure of Idriss and Boulanger (2014). CPT triggering uses the procedure of Boulanger and Idriss (2014) or of Robertson and Wride (1998).

What does the colour-band section show?

The factor of safety against liquefaction between the boreholes or soundings, with the triggered and marginal zones marked.

Do the modules give a report?

Yes. A project summary and a Word report close the work.