1The pile as a beam on springsThe equation, the moment and the shear, the conditions at the ends.
A pile loaded sideways bends like a beam and is held by the ground along its length. With z measured down from the ground surface and y the deflection of the pile in the direction of the load, the equation of the beam is
EI is the bending stiffness of the pile, P the axial load (compression) and p the reaction of the ground per unit length of the pile, which opposes the deflection. The slope, the bending moment and the shear force follow from the deflection:
At the tip the moment and the shear are zero. At the head the shear equals the lateral load H; a free head carries the moment Mg applied there (zero for a load alone), a fixed head, held against rotation by a cap, has zero slope and a moment that the cap supplies. A load applied a height e above the ground adds the moment He at the ground surface.
In the p–y method each spring follows a curve of the soil reaction p against the deflection y at its depth, which starts stiff and ends on the ultimate resistance of the soil there (see p–y curves for sand and clay). The equation then has no closed form. The GeoTerva laterally loaded pile module solves it by finite elements (cubic beam elements, the soil reaction integrated at four points in each) and Newton’s method, and gives the deflection, slope, moment, shear and soil reaction at every node of the pile.
2Free head and fixed headWhat holding the head changes.
Where the springs are elastic and grow in proportion to depth, k = nhz, Matlock and Reese (1960) wrote the response of a long pile with the relative stiffness T = (EI/nh)1/5 (see the coefficient of subgrade reaction). For a load H at the ground surface:
The engine of the module, in its elastic mode, gives Ay = 2.429 and Am = 0.772 at a depth of 1.33T for the free head, and Fy = 0.928, Fm = −0.927 for the fixed head. Holding the head against rotation therefore cuts the head deflection to 0.38 of the free value, but moves the largest moment up to the head and makes it 1.20 times the largest moment of the free pile, with the opposite sense: the pile is bent back by the cap. Below the head the moment of a fixed pile changes sign and reaches a smaller positive peak deeper down.
With non-linear p–y springs the same pattern holds, and the table below shows it for one pile. A real cap is neither perfectly rigid nor perfectly free; its rotation lies between the two cases.
3Head deflection and maximum moment against the loadOne pile in sand, free and fixed head.
A bored concrete pile, D = 0.80 m, L = 16 m, E = 30 000 MPa (EI = 603186 kN·m²), stands in a medium-dense sand with φ′ = 33°, γ = 18.5 kN/m³ above and γsat = 20 kN/m³ below the water table, 3 m down. The springs are the static API sand curves (Reese, Cox and Koop, 1974) with the initial modulus k = 26.5 MN/m³ above the water table and 14.6 MN/m³ below it. The load H acts at the ground surface, with no axial load.
| H (kN) | Free: y0 (mm) | Free: Mmax (kN·m) | Free: depth of Mmax (m) | Free: zero deflection at (m) | Fixed: y0 (mm) | Fixed: M at the head (kN·m) | Fixed: largest M below (kN·m) | Fixed: at depth (m) |
|---|---|---|---|---|---|---|---|---|
| 50 | 1.34 | 71.1 | 2.42 | 4.50 | 0.53 | −85.9 | 20.8 | 4.14 |
| 100 | 2.71 | 143.0 | 2.43 | 4.51 | 1.06 | −171.9 | 41.8 | 4.14 |
| 150 | 4.12 | 216.5 | 2.44 | 4.53 | 1.59 | −258.3 | 62.8 | 4.15 |
| 200 | 5.62 | 292.6 | 2.46 | 4.55 | 2.13 | −345.3 | 84.1 | 4.15 |
| 300 | 8.96 | 455.5 | 2.52 | 4.62 | 3.25 | −521.6 | 127.9 | 4.17 |
| 400 | 13.06 | 638.2 | 2.60 | 4.74 | 4.43 | −702.3 | 173.7 | 4.20 |
| 500 | 18.37 | 848.7 | 2.72 | 4.90 | 5.71 | −889.4 | 222.5 | 4.23 |
| 600 | 25.41 | 1093.7 | 2.87 | 5.11 | 7.11 | −1084.8 | 275.4 | 4.27 |
| 800 | 44.83 | 1681.1 | 3.27 | 5.52 | 10.46 | −1509.2 | 398.5 | 4.37 |
A negative moment at the fixed head is of the opposite sense to the moment below it (the pile is bent back by the cap). The largest moment is found between the nodes of the solution, where the shear passes through zero. Values computed by GeoTerva with the engine of its laterally loaded pile module.
The response is not proportional to the load. From 300 to 600 kN the head deflection of the free pile grows 2.84 times and the largest moment 2.40 times, and the depth of the largest moment moves down from 2.52 to 2.87 m: the sand near the surface approaches the end of its curve and passes the load deeper. At 600 kN the sand is at 95 % or more of the end of its curve from the surface down to 2.13 m.
4Along the pileDeflection, moment, shear and soil reaction at one load.
| z (m) | y (mm) | M (kN·m) | V (kN) | p (kN/m) | End of the p–y curve Apu (kN/m) | p / Apu |
|---|---|---|---|---|---|---|
| 0.00 | 8.96 | 0.0 | 300.0 | 0.0 | — | — |
| 0.80 | 6.54 | 228.2 | 255.7 | 107.8 | 145.6 | 0.74 |
| 1.60 | 4.36 | 390.7 | 143.6 | 159.9 | 267.9 | 0.60 |
| 2.40 | 2.58 | 454.5 | 17.3 | 151.9 | 337.9 | 0.45 |
| 3.20 | 1.27 | 424.5 | −78.4 | 59.0 | 541.1 | 0.11 |
| 4.00 | 0.41 | 346.7 | −111.5 | 23.9 | 735.7 | 0.03 |
| 4.80 | −0.08 | 253.2 | −118.2 | −5.8 | 959.4 | −0.01 |
| 5.60 | −0.31 | 162.8 | −105.1 | −25.0 | 1212.4 | −0.02 |
| 6.40 | −0.36 | 87.9 | −81.1 | −33.2 | 1494.6 | −0.02 |
| 8.00 | −0.23 | 0.3 | −30.3 | −26.6 | 2146.8 | −0.01 |
| 9.60 | −0.08 | −21.0 | −0.7 | −10.6 | 2916.0 | 0.00 |
| 12.00 | 0.01 | −8.6 | 6.1 | 1.8 | 4289.2 | 0.00 |
| 16.00 | 0.00 | 0.0 | 0.0 | −0.4 | 5647.1 | 0.00 |
z from the ground surface; y positive in the direction of the load; p the soil reaction per unit length; Apu the resistance on which the static API curve ends at that depth (zero at the surface). Values at the nodes of the solution, computed by GeoTerva with the engine of its laterally loaded pile module.
The pile deflects in the direction of the load down to 4.62 m and slightly back below it; below 9.2 m it moves less than 0.1 mm. The moment grows from zero at the free head to its peak where the shear passes through zero, and the soil reaction changes sign with the deflection. The last column shows how near the ground is to its limit: 0.74 of the end of its curve at 0.80 m, less than a tenth below 3.3 m. Most of the load is carried by the top few metres of sand.
5Worked exampleThe pile of Table 1 at 300 kN.
The pile and the sand of Table 1, the load H = 300 kN at the ground surface.
- Free head. The head deflects y0 = 8.96 mm and rotates 3.08 × 10⁻³ rad (0.176°), leaning over in the direction of the load. The largest bending moment is Mmax = 455.5 kN·m at z = 2.52 m (3.1D below the ground). The pile crosses its axis at 4.62 m; the shear, 300 kN at the head, changes sign at the depth of the largest moment and reaches −118.7 kN at 4.67 m. The tip moves 0.0016 mm: the pile is long for this load.
- The ground. The largest soil reaction is 161.4 kN/m at 1.73 m, where the sand curve ends on 276.0 kN/m: the ground there works at 58 % of its limit. The reaction summed over the pile is 300.000 kN, against H = 300 kN.
- Fixed head. Held against rotation, the head deflects 3.25 mm (0.36 of the free value) and the cap must hold a moment of 521.6 kN·m at the head, 1.15 times the largest moment of the free pile; below it the moment reverses and peaks at 127.9 kN·m at 4.17 m.
- Against elastic springs. With linear springs of the initial slope of the same p–y curves (nh = k: 26.5 and 14.6 MN/m³), the free head would deflect 8.02 mm at 300 kN, with Mmax = 425.5 kN·m. The p–y solution deflects 11.8 % more because the sand near the surface is already on the bent part of its curve; at H = 10 kN the two differ by 0.01 %, since every curve starts on its elastic tangent.
The same pile under 400 kN deflects 13.06 mm with the head free: whether that is acceptable is a matter of the allowable deflection of the structure, and whether 638 kN·m is, of the strength of the pile section. The module finds the load at which either limit is reached. In a group, the curves of each row are first reduced by its p-multiplier (see p-multipliers of a pile group).
6QuestionsShort answers.
Where is the maximum bending moment in a laterally loaded pile?
With the head free, below the ground, where the shear in the pile passes through zero: about 1.3T deep in an elastic ground whose stiffness grows with depth, and for the pile of Table 1 between 2.4 and 3.3 m, moving down as the load grows. With the head held against rotation, at the head.
How much does a fixed head reduce the deflection?
In an elastic ground with k = nhz a long pile held against rotation deflects 0.38 times as much as a free one under the same load (Matlock and Reese, 1960); for the pile of Table 1 at 300 kN it is 0.36. The price is a larger moment at the head, which the cap and the connection must carry.
Is the deflection of a pile proportional to the lateral load?
Only while the soil stays on the straight start of its p–y curves. As the load grows the soil near the surface yields, and the deflection grows faster than the load: for the pile of Table 1 doubling the load from 300 to 600 kN multiplies the head deflection by 2.84.