1The methodCoulomb’s wedge with a seismic force.
Mononobe (1929) and Okabe (1926) extended Coulomb’s active wedge with pseudo-static inertia forces khW and kvW. The resultant of gravity and inertia is inclined at
and for a vertical wall with level backfill and wall friction δ the coefficient is
There is no solution when φ − ψ is negative: the backfill cannot stand at that acceleration.
2Table of KAEVertical wall, level backfill, δ = φ/2, kv = 0.
| kh | φ = 25° | φ = 30° | φ = 35° | φ = 40° |
|---|---|---|---|---|
| 0.00 | 0.367 | 0.301 | 0.246 | 0.199 |
| 0.05 | 0.403 | 0.333 | 0.274 | 0.225 |
| 0.10 | 0.442 | 0.368 | 0.306 | 0.253 |
| 0.15 | 0.487 | 0.407 | 0.341 | 0.284 |
| 0.20 | 0.539 | 0.452 | 0.380 | 0.319 |
| 0.25 | 0.601 | 0.503 | 0.424 | 0.358 |
| 0.30 | 0.675 | 0.563 | 0.474 | 0.402 |
| 0.35 | 0.769 | 0.633 | 0.532 | 0.451 |
| 0.40 | 0.898 | 0.718 | 0.599 | 0.508 |
At kh = 0 the values are Coulomb’s Ka. Values computed by GeoTerva with the function its Mononobe–Okabe module uses.
3Worked exampleA 6 m wall, kh = 0.2.
A vertical wall H = 6 m retains dry sand with φ = 30°, δ = 15° and γ = 18 kN/m³; kh = 0.2, kv = 0. The table gives KAE = 0.452 (static Ka = 0.301).
PAE = ½ × 18 × 6² × 0.452 = 146.5 kN/m, against a static thrust of 97.7 kN/m: the earthquake adds 48.8 kN/m. This increment is usually taken to act higher on the wall than the static thrust (Seed and Whitman, about 0.6H above the base).
4QuestionsShort answers.
What is the difference between KA and KAE?
KA is the static active coefficient (Coulomb); KAE adds the pseudo-static seismic forces. At kh = kv = 0 the two are the same.
Why is there no value for large kh?
When ψ exceeds φ the active wedge cannot be in equilibrium for any failure angle; Mononobe–Okabe has no real solution there.
Should kv be included?
Many codes take kv = 0 or a fraction of kh; an upward kv (positive) reduces the weight of the wedge and the factor (1 − kv) enters PAE.